Stroud sits where the Five Valleys meet, about 11 miles west of Jack’s base in Cirencester. Jack already works in the area: he rewired a house in Chalford, a couple of miles up the valley, and the photos on this page are from that job. This page sets out the electrical work Stroud homes need most and what to send Jack before he quotes.

Working in Stroud and the valleys
Stroud had a population of 13,468 at the 2021 census, with about 60,000 people across the wider urban area. It grew as a cloth town: woollen mills along the small rivers of the valleys made the broadcloth known as Stroud cloth, using wool from Cotswold sheep. The town is known for its steep streets, and the Stroudwater Navigation and the Thames and Severn Canal, both being restored, run through the valley floor.
That history is protected. Stroud District Council’s Industrial Heritage Conservation Area was first designated in September 1987, one of the first places in Britain where industrial heritage was recognised as worth conserving. It follows the valley floors, including the Chalford valley, with its mills and the houses built around them. The town centre and several of the valley villages have conservation areas of their own.
For an electrician, that means a wide mix of buildings close together: stone cottages on steep hillsides, Victorian terraces in town, mill buildings, and newer estates on the edges. Each needs the work planned differently, from where the cables can run in a thick stone wall to how a charger cable reaches a parking space below the house.
Because the town is in Stroud district, notifiable electrical work here is either self-certified by an electrician registered with a competent person scheme or notified to Stroud District Council’s building control. It is a different council from Cirencester, but the rules are the same.
The map shows Stroud and the area around it. Open in Google Maps.
Stroud jobs and what to send Jack
The jobs Stroud homeowners, landlords and businesses most often need, what to send Jack before he quotes, and the guide that goes with each.
| The job | What to send Jack | Read first |
|---|---|---|
| Full or partial rewire | Which rooms or circuits are affected, whether the house is listed, and the finishes that must be kept. | Full or partial rewire |
| Consumer unit upgrade | A clear photo of the board with the cover on, and any work planned soon, such as solar, a charger or a new kitchen. | Consumer unit upgrade guide |
| Inspection before you buy or let (EICR) | The address, the age of the property if known, and any certificates you already have. | EICR for home buyers |
| Downlights and lighting | The rooms, the ceiling type and whether there is a room or loft above. | LED downlight cost |
| Home EV charger | A photo of the consumer unit and meter, a photo of where you park, and how far apart they are, including any steps or slope. | EV charger cost guide |
A rewire Jack did in Chalford
Chalford is a village in the valley just east of Stroud, inside the area the industrial heritage conservation area follows. Jack rewired a house there a couple of years ago, and the photographs on this page are from that job. The work covered:
- A rewire of the house.
- A new consumer unit with every way labelled, including lighting, central heating, garden, kitchen appliances, sockets, solar PV and the hob, with surge protection.
- Downlights, sockets and a wall TV point in the living areas.
- Lighting and power in the kitchen and the shower room.
The inspection label inside the consumer unit is dated 23 December 2023, with the next inspection due on 23 December 2028. The full write-up, with every photo, is on the Chalford rewire project page.
A labelled board like that one matters long after the electrician has gone. It tells you, and anyone who works on the house later, which switch controls which part of the home, and it is the first thing an inspector looks at.
Planning work in a valley home
Stroud’s hills shape the job as much as the house does. On a steep plot the meter may be at the bottom of the house and the parking at the top, or the other way round, and stone walls limit where cables can go. In an older or listed building, Historic England advises that services may need different routes from a modern home, to avoid permanent damage to the original fabric.
| The building | What to plan | Worth knowing |
|---|---|---|
| Stone cottage on a hillside | Cable routes through thick walls, and where the board and meter sit. | If it is listed, consent can apply to internal work. |
| Victorian terrace in town | Which rooms are affected, and how floors and ceilings will be opened and made good. | Much of the centre is a conservation area, which mostly concerns the outside. |
| Flat in a converted building | Who owns the shared parts and the supply, and whether a freeholder or management company must agree. | A charger may qualify for the GOV.UK grant for flat owners and renters. |
| Newer home on an estate | Board capacity and the cable route for a charger. | Homes built under Approved Document S from 15 June 2022 may already have charger access. |
Whatever the building, ask how the work will be certified before it starts. Under Part P of the Building Regulations, a new circuit or a replacement consumer unit in a home is notifiable work, and you should receive a certificate for it.

When Jack visits
Stroud is about 11 miles from Cirencester as the crow flies, a little further by road. For a quote, Jack looks at the consumer unit, the rooms involved and how cables can be routed. For an inspection, he needs access to every room and the board, and the power will be off for part of the testing.
On a steep plot, say where the meter, the board and any parking are in relation to each other. It saves a lot of guesswork before the visit.
What Jack does in Stroud
- Full and partial rewiresIncluding the Chalford house rewire near Stroud.
- Consumer unit upgradesLabelled boards with modern protection.
- EICRs and electrical safety reportsFor buyers, landlords and homeowners.
- Lighting and power alterationsDownlights, sockets and kitchen circuits.
- EV charger installation and servicingHome chargepoints, with the board and cable route checked first.
Photos from Jack’s work
More photographs from the Chalford rewire, showing the finished rooms.




Electrician in Stroud
Get a quote from Jack
Jack is about 11 miles from Stroud in Cirencester, so Stroud jobs are best planned ahead. Send these with your first message and the quote can be accurate from the start.
- Your postcode, so Jack can plan the visit.
- The property: house, cottage, flat, holiday let, barn or business unit, and roughly how old.
- What you need done, and by when.
- Any photos, plans or a previous certificate or report.
Call 07380 944864WhatsApp JackEmail Jack
It goes straight to Jack, no forms and no middleman. Prefer the full list of options? Ask for a quote on the contact page.
Guides for Stroud jobs
How to tell if a Cirencester home needs a full or partial rewire: the warning signs, what testing shows, older and listed homes, Part P certificates and quotes.
House rewire cost in Cirencester: dated UK market figures, VAT, access, finishes and paperwork to budget for before asking Jack for a fixed quotation.
What a consumer unit upgrade quote should include: pre-work checks, circuit protection, testing, certification and Part P notification in Cirencester.
What paperwork should follow a house rewire? Understand the Electrical Installation Certificate, test schedules and Building Regulations record.
Questions from Stroud
Does JI Electrical cover Stroud?
Yes. Jack is based in Cirencester, about 11 miles from Stroud, and has already rewired a house in Chalford, just up the valley. Call 07380 944864 or message him with your postcode and the job.
Who certifies electrical work in Stroud?
Notifiable work, such as a new circuit or a consumer unit replacement, is either self-certified by an electrician registered with a competent person scheme or notified to Stroud District Council’s building control. Ask how the job will be certified, and keep the certificate.
My house is in the industrial heritage conservation area. Does that affect a rewire?
Conservation area controls mostly concern the outside of a building. If the house is also listed, consent is needed for internal changes that affect its character, so check its listing first and agree cable routes that avoid damage to the original fabric.
Can I get an EV charger at a flat in Stroud?
Often, yes, if you have allocated off-street parking and the freeholder agrees. The GOV.UK chargepoint grant for flat owners and renters may help with the cost. Send Jack a photo of the parking space and where the flat’s meter and board are.
Is there a call-out or travel charge for Stroud?
Ask when you book. Any visit, call-out or travel charge should be stated before the visit and written on the quote.
Nearby areas
From Stroud, Jack also covers the valley villages, including Chalford, Brimscombe, Bisley, Minchinhampton, Nailsworth and Painswick.
- Electrician in South Cerney
- Electrician in Ashton Keynes
- Electrician in Poulton
- Electrician in Fairford
- Electrician in Tetbury
- Electrician in Cheltenham
- Every area Jack covers
Customer reviews
What customers say about Jack
Jack did a great job installing new spotlights in our kitchen. He turned up on time, worked efficiently, and everything was finished to a really high standard.
Jack and his colleague Freddie arrived on time, worked efficiently, and everything was completed to a really high standard. The price was fair and they left everything clean and tidy afterwards.
I contacted JI Eletrical within 24hrs with an issue and they came to fix it quickly and not had a problem since!
Sources
- Wikipedia: Stroud (population, cloth trade, canals)
- Stroud District Council: Industrial Heritage Conservation Area
- Historic England: installing services in an older home
- GOV.UK: Approved Document P, electrical safety in dwellings
- GOV.UK: Use a competent person scheme
- GOV.UK: Approved Document S, infrastructure for charging electric vehicles
- GOV.UK: EV chargepoint grant for renters and flat owners